Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| en:netzer:io [2014/09/28 09:28] – [Input capture (since version 1.6)] svesch | en:netzer:io [2025/06/11 20:42] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 138: | Line 138: | ||
| In impulse mode, individual or also continuous pulse sequencies may be generated. | In impulse mode, individual or also continuous pulse sequencies may be generated. | ||
| - | The pulse value is 16\ bit in width, but has a **minimum value of 100**, which cannot be fallen below. The value itself is written or read via the GPIO main page or via the [[gpioserver|GPIO server]] or [[commandinterface|command interface]]. The pulse length is internally buffered so that the output signal does not accept any inadmissible states in the event of amendments. | + | The pulse value is 16\ bit in width. The value itself is written or read via the GPIO main page or via the [[gpioserver|GPIO server]] or [[commandinterface|command interface]]. The pulse length is internally buffered so that the output signal does not accept any inadmissible states in the event of amendments. |
| The logic refers to the polarity of the pulse. 0-Logic means the pulse is 0, the pin accepts the 1-state. 1-logic means the pulse is 1, the pin accepts 0-state. | The logic refers to the polarity of the pulse. 0-Logic means the pulse is 0, the pin accepts the 1-state. 1-logic means the pulse is 1, the pin accepts 0-state. | ||