Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| en:netzer:spi-master [2015/12/23 17:22] – [Firmware pro version] Added single slave example svesch | en:netzer:spi-master [2025/06/11 20:42] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 129: | Line 129: | ||
| For using this SPI master in a single slave environment this example is provided here. | For using this SPI master in a single slave environment this example is provided here. | ||
| We assume that the slave is connected with the SPI_CS wire like shown below. | We assume that the slave is connected with the SPI_CS wire like shown below. | ||
| + | |||
| + | {{: | ||
| + | |||
| The SPI_CS shall be low active - a low level selects the slave. | The SPI_CS shall be low active - a low level selects the slave. | ||
| + | The pull up resistor at CS is needed to prevent false selection. | ||
| + | This may occur on power up if CS is not driven by Netzer. | ||
| + | The pull up resistor at SPI_MI is needed to prevent floating in case the slave is not selected and therefore the pin is not driven. | ||
| + | |||
| The data string < | The data string < | ||