Roadmap

• DNS Client (manual configurable or via DHCP)
• SNTP Client (manual configurable via IP or network name - name resolve via DNS is needed). Display current time on the index page.

• Map all states of the Netzer into a process image
• Direct mapping of process image members (i.e. interconnection of pins).
• Process image is accessable via HTTP
• ModbusTCP server implementation

• Activation of pins if a client is connected to GPIO or serial server (also inverted) → Is also done with the process image implementation.
• Changable GPIO names
• Configure state of GPIO pin in power down mode

• Configuration of an INT pin (one of the GPIOs)
• Extending the procotol for reading out this INT pin

• Configurable parity bit
• Handshake

• Integration of the PIC watchdog.
• Show the time since Netzer is active

• LCD board with Display (text or graphical), SD card, SRAM, EEPROM and Buzzer already in development
• Domestic board with Relais, Triac dimmer, temperature- and light sensor and 1-Wire-interface is also in development.
• Interface board with RS485 and RS232 (complete) - not started yet.

More of all! :) Not before 2012.