Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
en:netzer:impulse [2014/08/17 16:36]
svesch Added exmaples to all supported capture modes.
en:netzer:impulse [2014/09/27 21:50] (current)
svesch [Measuring impulses in „Triggered by IO0“ mode (IO0 synchronized)]
Line 105: Line 105:
 In this mode the periode of periodic signals or pulse length can be measured. In this mode the periode of periodic signals or pulse length can be measured.
 Connect the signal to measure to IO0 and IO3 or SPI_INT or both. Connect the signal to measure to IO0 and IO3 or SPI_INT or both.
-For periode ​length the IO0 trigger edge and the capture edge must be equal. +For period ​length the IO0 trigger edge and the capture edge must be equal (like IO3 in image below)
-For positive pulses the IO0 trigger edge must be rising, the capture edge falling edge.+For positive pulses the IO0 trigger edge must be rising, the capture edge falling edge (like SPI_INT in image below).
 For negative pulses the IO0 trigger edge must be falling, the capture edge rising edge. For negative pulses the IO0 trigger edge must be falling, the capture edge rising edge.
  
 {{ :​en:​netzer:​impulse_capture_io0_sync.gif?​direct |}} {{ :​en:​netzer:​impulse_capture_io0_sync.gif?​direct |}}
  

QR Code
QR Code Impulse handling with Netzer IO (generated for current page)