Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
en:netzer:io [2014/09/28 09:28]
svesch [Input capture (since version 1.6)]
en:netzer:io [2014/09/28 09:50] (current)
svesch [Impulse output]
Line 138: Line 138:
 In impulse mode, individual or also continuous pulse sequencies may be generated. ​ In impulse mode, individual or also continuous pulse sequencies may be generated. ​
  
-The pulse value is 16\ bit in width, but has a **minimum value of 100**, which cannot be fallen below. The value itself is written or read via the GPIO main page or via the [[gpioserver|GPIO server]] or [[commandinterface|command interface]]. The pulse length is internally buffered so that the output signal does not accept any inadmissible states in the event of amendments. ​+The pulse value is 16\ bit in width. The value itself is written or read via the GPIO main page or via the [[gpioserver|GPIO server]] or [[commandinterface|command interface]]. The pulse length is internally buffered so that the output signal does not accept any inadmissible states in the event of amendments. ​
  
 The logic refers to the polarity of the pulse. 0-Logic means the pulse is 0, the pin accepts the 1-state. 1-logic means the pulse is 1, the pin accepts 0-state. The logic refers to the polarity of the pulse. 0-Logic means the pulse is 0, the pin accepts the 1-state. 1-logic means the pulse is 1, the pin accepts 0-state.

QR Code
QR Code Netzer IO (generated for current page)