Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
en:netzer:pins [2011/12/19 12:23] 127.0.0.1 external edit |
en:netzer:pins [2014/01/04 18:03] svesch Added common overview |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Netzer pin map ====== | ||
| - | |||
| - | {{ :netzer_top.png?nolink& |}} | ||
| - | |||
| - | ===== Overview ===== | ||
| - | |||
| - | **Pins of pin header JP1**\\ | ||
| - | ^ Name ^ Description ^ | ||
| - | | INT | GPIO pins, see [[en:netzer:io|IO]] for more information. | | ||
| - | | CLK | ::: | | ||
| - | | MI | ::: | | ||
| - | | MO | ::: | | ||
| - | | CS | ::: | | ||
| - | | IO4 | ::: | | ||
| - | | IO5 | ::: | | ||
| - | | IO3 | ::: | | ||
| - | | VA2 | Connection for [[en:netzer:pins#Power-over-Ethernet (PoE)|Power-over-Ethernet]]. That is the center tap of the Ethernet coil between RJ45 pins 3 and 6. | | ||
| - | | VB2 | Connection for [[en:netzer:pins#Power-over-Ethernet (PoE)|Power-over-Ethernet]]. This pin is directly connected to the network jack of Netzer (RJ45 pins 7 and 8). | | ||
| - | |||
| - | **Pins of pin header JP2**\\ | ||
| - | ^ Name ^ Description ^ | ||
| - | | RST | Use this pin to reset Netzer. The signal is low active (this means 0 resets Netzer). The Reset signal can also be used for waking up Netzer from sleep mode (after shut down). The pin is optional and can be left open.| | ||
| - | | 3V3 | Pin for power supply. Minimum voltage is 3.1\ V. Maximum voltage is 3.6\ V.| | ||
| - | | GND | Ground potential.| | ||
| - | | IO0 | GPIO pins, see [[en:netzer:io|IO]] for more information. | | ||
| - | | IO1 | ::: | | ||
| - | | IO2 | ::: | | ||
| - | | TX | ::: | | ||
| - | | RX | ::: | | ||
| - | | VA1 | Connection for [[en:netzer:pins#Power-over-Ethernet (PoE)|Power-over-Ethernet]]. That is the center tap of the ethernet coil between RJ45 pins 1 and 2. | | ||
| - | | VB1 | Connection for [[en:netzer:pins#Power-over-Ethernet (PoE)|Power-over-Ethernet]]. This pin is directly connected to the network jack of Netzer (RJ45 pins 4 and 5). | | ||
| - | |||
| - | |||
| - | ===== Power-over-Ethernet (PoE) ===== | ||
| - | |||
| - | The four connections VA1, VA2, VB1 and VB2 are connections from the network socket where a Power-over-Ethernet supply can be connected to. | ||
| - | |||
| - | {{ :poe.gif?nolink& |PoE example circuit}} | ||
| - | The image shows an example circuit. Here the PoE supply AG9033 of Silver Telecom is used. | ||
